|
|
Fire case by Wolverine
Author: Magnus PerssonPublished: 19th December 2006
By the time I had finished doing the flames - slowly - my plexi had arrived, so I did a quick test fitting. After a lot more cutting and filing I finally had the cutout completed and I started playing around with some different coloured plexi pieces to enhance the flame effect.
Right Side Cutout
Now it was time to get going on the other side. I did this exactly the same way as the first, so there's not much to mention here.
I engraved a pattern on the site and then fired up the routing table to get to work.
Here's a picture of the right side with the plexi mounted and some nice lights.
Shopping
Stats: 0.022 seconds