Na'ir al Saif by Attila Lukacs

Finishing off

Having finished most of the building work I still had to decide what colour to finish the case.




The chassis was then wired up, the PSU repainted and installed. All that was left was to make the case shell.




A simple shell was made from clear plexiglass. Although I started to model a back-plate in cardboard, it soon became obvious how flimsy it would be if I wanted to retain good airflow. So I omitted this section completely.




And that’s it! I hope you all enjoyed watching the building of Na’ir al Saif. Head over to the gallery page for some final photos of the case. See you all again soon with a very small and very complex PC. In fact, I'm probably working on it while you read this.