bit-tech.net

Corsair 460X Build for BoMenzzz: Part Two

Comments 1 to 2 of 2

Reply
Impatience 21st March 2017, 17:47 Quote
Really enjoying this little series! ;) With the rear panel, did you measure where the motherboard standoffs are and cut out holes, or does the panel nor go the full way across the side of the case? Just asking as wanting to do something similar for my 350D. (as it's got a giant hole in the rear wall where the ODD/HDD cages are!)
davido_labido 22nd March 2017, 11:16 Quote
Quote:
Originally Posted by Impatience
Really enjoying this little series! ;) With the rear panel, did you measure where the motherboard standoffs are and cut out holes, or does the panel nor go the full way across the side of the case? Just asking as wanting to do something similar for my 350D. (as it's got a giant hole in the rear wall where the ODD/HDD cages are!)


I made it so that the panel just touched the standoffs, there is no need to go any further really. If you did want to though, just use a 4mm drill bit and you would get a rather nice fit for them :)
Log in

You are not logged in, please login with your forum account below. If you don't already have an account please register to start contributing.



Discuss in the forums