bit-tech.net

Scratchbuilt PC: More water-cooling and the roof section

Comments 1 to 4 of 4

Reply
guvnar 2nd November 2012, 13:49 Quote
"End result?" Hardly, there's black tape holding it together...

Please finish it then post pictures so we can see the real "end result"!
Combatus 2nd November 2012, 14:33 Quote
Quote:
Originally Posted by guvnar
"End result?" Hardly, there's black tape holding it together...

Please finish it then post pictures so we can see the real "end result"!

We can't show what doesn't exist ;) This is part seven of a diary of guides and lots more to come where we finish the roof section. At the moment this is all there is to see before we've cut it to shape and ironed out the bumps. We'll be showing more progress in the next instalment ;)
Dave Lister 2nd November 2012, 17:34 Quote
I thought you guys had given up on this, nice to see some more progress it's looking good.
mclean007 4th November 2012, 09:21 Quote
To get a nice smooth curve in the acrylic, lay it out over a pipe of the appropriate diameter, which then supports it along the entire length of the bend, rather than trying to bend it into place on the case, which only supports it at 2 edges. That should let you get a beautiful even curve.
Log in

You are not logged in, please login with your forum account below. If you don't already have an account please register to start contributing.



Discuss in the forums