bit-tech.net

Nanoxia Project S Water-Cooling Build: Part Three

Comments 1 to 6 of 6

Reply
The_Crapman 22nd November 2016, 14:32 Quote
Very nice ;)
Neutronman 22nd November 2016, 16:44 Quote
Looking good. I've just started to put together a shopping list for my next build and this will be my first build with Rigid tubing. I tried acrylic a few years back and just could not get a decent bend.
Perhaps I'll post my build here after completed.
stealth80 22nd November 2016, 18:54 Quote
Looks great, apart from one eye sore! Could that 8 pin atx cable not have been routed behind the board ? There's even a cable management hole for it :D
Combatus 22nd November 2016, 20:03 Quote
Quote:
Originally Posted by stealth80
Looks great, apart from one eye sore! Could that 8 pin atx cable not have been routed behind the board ? There's even a cable management hole for it :D

There is, but it's completely blocked by the radiator - not even enough room for the cables to thread through!
stealth80 24th November 2016, 07:52 Quote
Quote:
Originally Posted by Combatus
There is, but it's completely blocked by the radiator - not even enough room for the cables to thread through!


That's a shame, looks great non-the less;)
Combatus 26th November 2016, 22:58 Quote
Quote:
Originally Posted by stealth80
Quote:
Originally Posted by Combatus
There is, but it's completely blocked by the radiator - not even enough room for the cables to thread through!


That's a shame, looks great non-the less;)

Thanks :) The cable looks much better in person. If I could go back I'd maybe route it under the motherboard but the ModMesh cables probably aren't that flexible. Still it's otherwise a great case.
Log in

You are not logged in, please login with your forum account below. If you don't already have an account please register to start contributing.



Discuss in the forums